Optical Systems Design OSD2700SFP SERIES Operator's Manual page 206

4. Example:
The following example enables IGMP snooping fast-leave on vlan1.1:
switch_a(config)#interface vlan1.1
switch_a(config-if)#ip igmp snooping fast-leave
switch_a(config-if)#
IGMP querier:
Query-interval:
1. Command Mode: Interface mode
Logon to Configure Mode (Configure Terminal Mode).
Then logon to Interface mode.
vlan1.1 means vlan 1.
The switch_a(config-if)# prompt will show on the screen.
switch_a(config)#interface vlan1.1
switch_a(config-if)#
2. Usage:
Use ip igmp query-interval command to configure the frequency of sending IGMP host query
messages.
To return to the default frequency, use the no ip igmp query-interval command.
3. Command Syntax:
ip igmp query-interval INTERVAL
no ip igmp query-interval
INTERVAL <1-18000> Frequency (in seconds) at which IGMP host query messages are sent.
Default: 125 seconds.
4. Example:
The following example changes the frequency of sending IGMP host-query messages to 2 minutes on
vlan1.1:
switch_a(config)#interface vlan1.1
switch_a(config-if)#ip igmp query-interval 120
switch_a(config-if)#
IGMP querier:
Max-response-time:
1. Command Mode: Interface mode
Logon to Configure Mode (Configure Terminal Mode).
Then logon to Interface mode.
vlan1.1 means vlan 1.
The switch_a(config-if)# prompt will show on the screen.
switch_a(config)#interface vlan1.1
switch_a(config-if)#
2. Usage:
Use ip igmp query-max-response-time command to configure the maximum response time advertised
in IGMP queries.
To restore to the default value, use the no ip igmp query-max-response-time command.
3. Command Syntax:
PAGE 206
OSD2700SFP OPERATOR MANUAL
OPTICAL SYSTEMS DESIGN
DOC ID: 10112704