Other Protocols - Optical Systems Design OSD2700SFP SERIES Operator's Manual

7.14 OTHER PROTOCOLS

GVRP, IGMP Snooping, NTP, GMRP, DHCP Server
GVRP
GVRP:
1. Command Mode: Configure mode
Logon to Configure Mode (Configure Terminal Mode).
The switch_a(config)# prompt will show on the screen.
switch_a(config)#
2. Usage:
Use set gvrp enable bridge command to enable (set) and set gvrp disable bridge command to disable
(reset) GVRP globally for the bridge instance. This command does not enable/disable GVRP in all
ports of the bridge. After enabling GVRP globally, use the set port gvrp enable command to enable
GVRP on individual ports of the bridge.
3. Command Syntax:
set gvrp enable bridge GROUP
set gvrp disable bridge GROUP
GROUP Bridge-group ID used for bridging.
4. Example:
The following example globally enables GVRP to bridge GROUP (1):
switch_a(config)#set gvrp enable bridge 1
switch_a(config)#
Dynamic VLAN creation:
1. Command Mode: Configure mode
Logon to Configure Mode (Configure Terminal Mode).
The switch_a(config)# prompt will show on the screen.
switch_a(config)#
2. Usage:
Use set gvrp dynamic-vlan-creation enable bridge command to enable and set gvrp dynamic-vlan-
creation disable bridge command to disable dynamic VLAN creation for a specific bridge instance.
3. Command Syntax:
set gvrp dynamic-vlan-creation enable bridge GROUP
set gvrp dynamic-vlan-creation disable bridge GROUP
GROUP Bridge-group ID used for bridging.
4. Example:
The following example enables dynamic VLAN creation for bridge GROUP (1):
switch_a(config)#set gvrp dynamic-vlan-creation enable bridge 1
switch_a(config)#
Per port setting:
GVRP:
PAGE 202
OSD2700SFP OPERATOR MANUAL
OPTICAL SYSTEMS DESIGN
DOC ID: 10112704