Optical Systems Design OSD2700SFP SERIES Operator's Manual page 142

fe1 means port 1.
The switch_a(config-if)# prompt will show on the screen.
switch_a(config)#interface fe1
switch_a(config-if)#
2. Usage:
Use storm-control dlf enable command to enable destination lookup failure traffic.
Use no storm-control dlf command to disable destination lookup failure traffic.
3. Command Syntax:
storm-control dlf enable
no storm-control dlf
dlf destination lookup failure
4. Example:
The following example shows setting storm-control dlf enable to the interface fe1 (port 1):
switch_a(config)#interface fe1
switch_a(config-if)#storm-control dlf enable
switch_a(config-if)#
Port isolation:
1. Command Mode: Interface mode
Logon to Configure Mode (Configure Terminal Mode).
Then logon to Interface mode.
fe1 means port 1.
The switch_a(config-if)# prompt will show on the screen.
switch_a(config)#interface fe1
switch_a(config-if)#
2. Usage:
Use port-isolation enable command to enable port isolation.
Use port-isolation disable command to disable port isolation.
3. Command Syntax:
port-isolation (enable ｜ disable)
4. Example:
The following example enables port-isolation to the interface fe1 (port 1):
switch_a(config)#interface fe1
switch_a(config-if)#port-isolation enable
switch_a(config-if)#
LOOPBACK DETECT
LoopBack Detect:
1. Command Mode: Configure mode
Logon to Configure Mode (Configure Terminal Mode).
The switch_a(config)# prompt will show on the screen.
switch_a(config)#
2. Usage:
PAGE 142
OSD2700SFP OPERATOR MANUAL
OPTICAL SYSTEMS DESIGN
DOC ID: 10112704