Optical Systems Design OSD2700SFP SERIES Operator's Manual page 181

Class Map:
1. Command Mode: Configure mode
Logon to Configure Mode (Configure Terminal Mode).
The switch_a(config)# prompt will show on the screen.
switch_a(config)#
2. Usage:
Use class-map command to create a class map and no class-map command to delete a class map.
3. Command Syntax:
(no) class-map NAME
NAME Class map name.
4. Example:
Create a class map c1.
switch_a(config)#class-map c1
switch_a(config-cmap)#
Attach Class Map to Policy Map:
1. Command Mode: Configure mode
Logon to Configure Mode (Configure Terminal Mode).
The switch_a(config)# prompt will show on the screen.
switch_a(config)#
2. Usage:
Use class command to match a class map to a policy map and no class command to dismiss a class
map from a policy map.
3. Command Syntax:
(no) class NAME
NAME Class map name.
4. Example:
Match a class map c1 to a policy map p1.
switch_a(config)#policy-map p1
switch_a(config-pmap)#class c1
switch_a(config-pmap-c)#
Set Traffic Rate and Burst Size:
1. Command Mode: Configure mode
Logon to Configure Mode (Configure Terminal Mode).
The switch_a(config)# prompt will show on the screen.
switch_a(config)#
2. Usage:
Use this command to set average traffic rate and normal burst size in an access group.
3. Command Syntax:
police RATE BURST exceed-action drop
RATE <1-1000000> Specify an average traffic rate (kbps).
BURST <1-20000> Specify a normal burst size (bytes).
PAGE 181
OSD2700SFP OPERATOR MANUAL
OPTICAL SYSTEMS DESIGN
DOC ID: 10112704