Optical Systems Design OSD2700SFP SERIES Operator's Manual page 166

Use this command to enable Ring-coupling state. Use the no parameter with this command to disable
Ring-coupling state.
3. Command Syntax:
(no) ring-coupling enable
4. Example:
The following example enables Ring-coupling state:
switch_a(config)#ring-coupling enable
switch_a(config)#
Set ring-coupling port:
1. Command Mode: Configure mode
Logon to Configure Mode (Configure Terminal Mode).
The switch_a(config)# prompt will show on the screen.
switch_a(config)#
2. Usage:
Use this command to set Ring-coupling port 1 and Ring-coupling port 2.
3. Command Syntax:
ring set-coupling-port COUPLING_PORT_1 COUPLING_PORT_2
COUPLING_PORT_1 Specify the Ring-coupling port 1.
COUPLING_PORT_2 Specify the Ring-coupling port 2.
4. Example:
The following example sets the fe3 and fe4 as Ring-coupling port 1 and Ring-coupling port 2:
switch_a(config)#ring set-coupling-port fe3 fe4
switch_a(config)#
CHAIN SETTING
Chain Protocol:
1. Command Mode: Interface mode
Logon to Configure Mode (Configure Terminal Mode).
Then logon to Interface mode.
fe1 means port 1.
The switch_a(config-if)# prompt will show on the screen.
switch_a(config)#interface fe1
switch_a(config-if)#
2. Usage:
Use this command to set Chain Protocol to an interface. Use the no parameter with this command to
revoke Chain Protocol from an interface.
3. Command Syntax:
chain port enable
no chain port
4. Example:
The following example sets Chain Protocol to the interface fe1 (port 1):
switch_a(config)#interface fe1
switch_a(config-if)#chain port enable
switch_a(config-if)#
PAGE 166
OSD2700SFP OPERATOR MANUAL
OPTICAL SYSTEMS DESIGN
DOC ID: 10112704