Osd2700Sfp Operation - Optical Systems Design OSD2700SFP SERIES Operator's Manual

3.3

OSD2700SFP OPERATION

When using the OSD2700SFP for the first time, check that the unit is in good condition with no visible
damage.
Connect the unit to an appropriate power source and check that the indicators illuminate accordingly on
power up (see Table 4) after all other connections have been made.
3.3.1 CABLE CONNECTIONS
It is necessary to follow the cable specifications below when connecting the switch to your network.
Use appropriate cables that meet your speed and cabling requirements.
Speed Connector
100Base-TX RJ-45
1000Base-T RJ-45
100Base-FX LC
100Base-FX LC
100Base-BX LC
100Base-BX LC
SFP
1000Base-SX Duplex LC
1000Base-LX Duplex LC
1000Base-BX Duplex LC
Step 1: First, ensure the power of the switch and end devices are turned off.
Step 2: Prepare cable with corresponding connectors for each type of port in use.
Step 3: Consult Cable Specifications Table on previous page for cabling requirements based on
connectors and speed.
Step 4: Connect one end of the cable to the switch and the other end to a desired device.
Step 5: Once the connections between two end devices are made successfully, turn on the power and
the switch is operational.
*Note: The 4 Gigabit SFP ports and 4 fixed Copper Ports are combo ports. It is possible to use either the
RJ45 port of the SFP port per channel (G1, G2, G3, G4). Ie It is not possible to use both at the same
time
PAGE 16
OSD2700SFP OPERATOR MANUAL
OPTICAL SYSTEMS DESIGN
TABLE 5: CABLE SPECIFICATIONS
Port Speed
Half/Full Duplex
100/200 Mbps 2-pair UTP/STP Cat. 5
2000 Mbps 4-pair UTP/STP Cat. 5
200 Mbps MMF (62.5µm)
200 Mbps SMF (10µm)
200 Mbps MMF (62.5µm)
200 Mbps SMF (10µm)
2000 Mbps MMF (62.5µm)
2000 Mbps SMF (10µm)
2000 Mbps SMF (10µm)
Cable
100m
100m
2km
20, 40, 75, 100km
2, 5km
20, 40km
550m
2km
10, 40, 60km
70km
DOC ID: 10112704
Max.
Distance