Primary Accounting (Radius Scheme View) - HP HSR6600 Command Reference Manual

The source IP address specified for outgoing RADIUS packets must be of the same IP version as the IP
addresses of the RADIUS servers in the RADIUS scheme. Otherwise, the source IP address configuration
does not take effect.
A RADIUS scheme can have only one source IP address for outgoing RADIUS packets. If you specify a
new source IP address for the same RADIUS scheme, the new one overwrites the old one.
The setting configured by the nas-ip command in RADIUS scheme view is only for the RADIUS scheme,
whereas that configured by the radius nas-ip command in system view is for all RADIUS schemes. The
setting in RADIUS scheme view takes precedence.
Examples
# Set the source IP address for outgoing RADIUS packets to 10.1.1.1.
<Sysname> system-view
[Sysname] radius scheme radius1
[Sysname-radius-radius1] nas-ip 10.1.1.1
Related commands
radius nas-ip

primary accounting (RADIUS scheme view)

Use primary accounting to specify the primary RADIUS accounting server.
Use undo primary accounting to remove the configuration.
Syntax
primary accounting { ipv4-address | ipv6 ipv6-address } [ port-number | key [ cipher | simple ] key |
vpn-instance vpn-instance-name ] *
undo primary accounting
Default
No primary RADIUS accounting server is specified.
Views
RADIUS scheme view
Default command level
2: System level
Parameters
ipv4-address: Specifies the IPv4 address of the primary RADIUS accounting server.
ipv6 ipv6-address: Specifies the IPv6 address of the primary RADIUS accounting server, which must be
a valid global unicast address.
port-number: Specifies the service port number of the primary RADIUS accounting server, which is a UDP
port number ranging from 1 to 65535 and defaults to 1813.
key [ cipher | simple ] key: Specifies the shared key for secure communication with the primary RADIUS
accounting server. In FIPS mode, the shared key must be a string of at least 8 characters that contain
numbers, uppercase letters, lowercase letters, and special characters, and is encrypted and decrypted
by using 3DES.
73