HP HSR6600 Command Reference Manual page 147

Syntax
In system view:
dot1x max-user user-number [ interface interface-list ]
undo dot1x max-user [ interface interface-list ]
In Ethernet interface view:
dot1x max-user user-number
undo dot1x max-user
Default
The port supports a maximum of 1024 concurrent 802.1X users.
Views
System view, Ethernet interface view
Default command level
2: System level
Parameters
user-number: Specifies the maximum number of concurrent 802.1X users on a port. The value range is 1
to 1024.
interface interface-list: Specifies an Ethernet port list, which can contain multiple Ethernet ports. The
interface-list argument is in the format of interface-list = { interface-type interface-number [ to
interface-type interface-number ] } & <1- 1 0>, where interface-type represents the port type,
interface-number represents the port number, and & <1- 1 0> means that you can provide up to 10 ports
or port ranges. The start port number must be smaller than the end number and the two ports must be of
the same type.
Usage guidelines
In system view:
If you do not specify the interface-list argument, the command applies to all ports.
•
If you specify the interface-list argument, the command applies to the specified ports.
•
In Ethernet port view, the interface interface-list option is not available and the command applies to only
the Ethernet port.
Examples
# Set the maximum number of concurrent 802.1X users on port GigabitEthernet 3/0/1 to 32.
<Sysname> system-view
[Sysname] dot1x max-user 32 interface gigabitethernet 3/0/1
Or
<Sysname> system-view
[Sysname] interface gigabitethernet 3/0/1
[Sysname-GigabitEthernet3/0/1] dot1x max-user 32
# Configure GigabitEthernet 3/0/2 through GigabitEthernet 3/0/5 each to support a maximum of 32
concurrent 802.1X users.
<Sysname> system-view
[Sysname] dot1x max-user 32 interface gigabitethernet 3/0/2 to gigabitethernet 3/0/5
134