Radius Client - HP HSR6600 Command Reference Manual

Hide thumbs Also See for HSR6600:
Table of Contents

Advertisement

If the specified server resides on an MPLS L3VPN, specify the VPN by using the vpn-instance
vpn-instance-name option. The VPN specified by this command takes precedence over the VPN
specified for the RADIUS scheme.
If you remove the primary authentication server when an authentication process is in progress, the
communication with the primary server times out, and the device looks for a server in active state from the
new primary server on.
With the server status detection feature enabled, the device sends an authentication request that carries
the specified username to the primary server at the specified interval. If the device receives no response
from the server within the time interval specified by the timer response-timeout command, the device
sends the authentication request again.
If the maximum number of retries (specified by the retry command) is reached and the device still receives
no response from the server, the device considers the server as unreachable. If the device receives a
response from the server before the maximum number of retries is reached, the device considers the
server as reachable. The device sets the status of the server to block or active according to the status
detection result, regardless of the current status of the server.
For 802.1X authentication, if the status of every server is block, the device assigns the port connected to
an authentication user to the specified 802.1X critical VLAN. For more information about the 802.1X
critical VLAN, see Security Configuration Guide.
To ensure that the device can set the server to its actual status, set a longer quiet timer for the primary
server with the timer quiet command. If you set a short quiet timer and configure 802.1X critical VLAN on
a port, the device might frequently change the server status, and the port might frequently join and leave
the critical VLAN.
Examples
# For RADIUS scheme radius1, set the IP address of the primary authentication/authorization server to
10.1 10.1.1, the UDP port to 1812, and the shared key to hello in plain text.
<Sysname> system-view
[Sysname] radius scheme radius1
[Sysname-radius-radius1] primary authentication 10.110.1.1 1812 key hello
# In RADIUS scheme radius1, set the username used for status detection of the primary
authentication/authorization server to test, and set the server status detection interval to 120 minutes.
<Sysname> system-view
[Sysname] radius scheme radius1
[Sysname-radius-radius1] primary authentication 10.110.1.1 probe username test interval
120
Related commands
key (RADIUS scheme view)
vpn-instance (RADIUS scheme view)

radius client

Use radius client enable to enable the RADIUS client service.
Use undo radius client to disable the RADIUS client service.
Syntax
radius client enable
76

Advertisement

Table of Contents
loading

This manual is also suitable for:

Hp 6600

Table of Contents