Display Attack-Defense Policy - HP HSR6600 Command Reference Manual

defense udp-flood enable
•
•

display attack-defense policy

display attack-defense policy
Use display attack-defense policy to display configuration information about one or all attack protection
policies.
Syntax
display attack-defense policy [ policy-number ] [ | { begin | exclude | include } regular-expression ]
Views
Any view
Default command level
1: Monitor level
Parameters
policy-number: Sequence number of an attack protection policy, in the range of 1 to 128. If you do not
specify this argument, this command displays all brief information about attack protection policies.
|: Filters command output by specifying a regular expression. For more information about regular
expressions, see Fundamentals Configuration Guide.
begin: Displays the first line that matches the specified regular expression and all lines that follow.
exclude: Displays all lines that do not match the specified regular expression.
include: Displays all lines that match the specified regular expression.
regular-expression: Specifies a regular expression, a case-sensitive string of 1 to 256 characters.
Examples
# Display configuration information about attack protection policy 1.
<Sysname> display attack-defense policy 1
------------------------------------------------------------
Policy number
Bound interfaces
------------------------------------------------------------
Smurf attack-defense
ICMP redirect attack-defense
ICMP unreachable attack-defense
Large ICMP attack-defense
Max-length
TCP flag attack-defense
Tracert attack-defense
Fraggle attack-defense
WinNuke attack-defense
LAND attack-defense
Source route attack-defense
Route record attack-defense
Scan attack-defense
Attack-defense Policy Information
: 1
: GigabitEthernet3/0/1
: Enabled
: Disabled
: Disabled
: Enabled
: 250 bytes
: Enabled
: Enabled
: Enabled
: Enabled
: Enabled
: Enabled
: Enabled
: Enabled
474