Dot1X - HP HSR6600 Command Reference Manual

dot1x

Use dot1x to enable 802.1X.
Use undo dot1x to disable 802.1X.
Syntax
In system view:
dot1x [ interface interface-list ]
undo dot1x [ interface interface-list ]
In Ethernet interface view:
dot1x
undo dot1x
Default
802.1X is neither enabled globally nor enabled for any port.
Views
System view, Ethernet interface view
Default command level
2: System level
Parameters
interface interface-list: Specifies a port list, which can contain multiple ports. The interface-list argument
is in the format of interface-list = { interface-type interface-number [ to interface-type interface-number ] }
& <1- 1 0>, where interface-type represents the port type, interface-number represents the port number,
and & <1- 1 0> means that you can provide up to 10 ports or port ranges. The start port number must be
smaller than the end number and the two ports must be of the same type.
Usage guidelines
Use the dot1x command in system view to enable 802.1X globally.
Use the undo dot1x command in system view to disable 802.1X globally.
Use the dot1x interface command in system view or the dot1x command in interface view to enable
802.1X for specified ports.
Use the undo dot1x interface command in system view or the undo dot1x command in interface view to
disable 802.1X for specified ports.
802.1X must be enabled both globally in system view and for the intended ports in system view or
interface view. Otherwise, it does not function.
You can configure 802.1X parameters either before or after enabling 802.1X.
Examples
# Enable 802.1X for ports GigabitEthernet 3/0/1, and GigabitEthernet 3/0/5 to GigabitEthernet
3/0/7.
<Sysname> system-view
[Sysname] dot1x interface gigabitethernet 3/0/1 gigabitethernet 3/0/5 to gigabitethernet
3/0/7
124