802.1X Commands; Display Dot1X - HP HSR6600 Command Reference Manual

802.1X commands

802.1X commands are supported only on a SAP module that is operating in bridge mode.

display dot1x

Use display dot1x to display information about 802.1X.
Syntax
display dot1x [ sessions | statistics ] [ interface interface-list ] [ | { begin | exclude | include }
regular-expression ]
Views
Any view
Default command level
1: Monitor level
Parameters
sessions: Displays 802.1X session information.
statistics: Displays 802.1X statistics.
interface interface-list: Specifies an Ethernet port list, which can contain multiple Ethernet ports. The
interface-list argument is in the format of interface-list = { interface-type interface-number [ to
interface-type interface-number ] } & <1- 1 0>, where interface-type represents the port type,
interface-number represents the port number, and & <1- 1 0> means that you can provide up to 10 ports
or port ranges. The start port number must be smaller than the end number and the two ports must be the
same type.
|: Filters command output by specifying a regular expression. For more information about regular
expressions, see Fundamentals Configuration Guide.
begin: Displays the first line that matches the specified regular expression and all lines that follow.
exclude: Displays all lines that do not match the specified regular expression.
include: Displays all lines that match the specified regular expression.
regular-expression: Specifies a regular expression, a case-sensitive string of 1 to 256 characters.
Usage guidelines
If you do not specify the sessions or statistics keyword, the command displays all information about
802.1X, including session information, statistics, and configurations.
Examples
# Display all information about 802.1X.
<Sysname> display dot1x
Equipment 802.1X protocol is enabled
CHAP authentication is enabled
Proxy trap checker is disabled
Proxy logoff checker is disabled
120