Sftp Client Source - HP HSR6600 Command Reference Manual

Use undo sftp client ipv6 source to remove the configuration.
Syntax
sftp client ipv6 source { interface interface-type interface-number | ipv6 ipv6-address }
undo sftp client ipv6 source
Default
An SFTP client uses the IPv6 address of the interface specified by the route of the device to access the
SFTP server.
Views
System view
Default command level
3: Manage level
Parameters
interface interface-type interface-number: Specifies a source interface by its type and number.
ipv6 ipv6-address: Specifies a source IPv6 address.
Usage guidelines
To make sure the SFTP client and the SFTP server can communicate with each other, and to improve the
manageability of SFTP clients in the authentication service, HP recommends you to specify a loopback
interface as the source interface.
Examples
# Specify the source IPv6 address of the SFTP client as 2:2::2:2.
<Sysname> system-view
[Sysname] sftp client ipv6 source ipv6 2:2::2:2
Related commands
display sftp client source

sftp client source

Use sftp client source to specify the source IPv4 address or interface of an SFTP client.
Use undo sftp client source to remove the configuration.
Syntax
sftp client source { interface interface-type interface-number | ip ip-address }
undo sftp client source
Default
An SFTP client uses the IP address of the interface specified by the route of the device to access the SFTP
server.
Views
System view
Default command level
3: Manage level
377