Timer Realtime-Accounting (Radius Scheme View) - HP HSR6600 Command Reference Manual

Usage guidelines
The quiet timer controls whether the device changes the status of an unreachable server from active to
blocked and how long the device keeps an unreachable server in blocked state.
If you determine that the primary server is unreachable because the device's port connected to the server
is out of service temporarily or the server is busy, you can set the server quiet period to 0 so that the
device uses the primary server whenever possible.
Be sure to set the server quiet timer properly. Too short a quiet timer may result in frequent authentication
or accounting failures because the device keeps trying to communicate with an unreachable server that
is in active state.
Examples
# Set the quiet timer for the servers to 10 minutes.
<Sysname> system-view
[Sysname] radius scheme radius1
[Sysname-radius-radius1] timer quiet 10
Related commands
display radius scheme

timer realtime-accounting (RADIUS scheme view)

Use timer realtime-accounting to set the real-time accounting interval.
Use undo timer realtime-accounting to restore the default.
Syntax
timer realtime-accounting minutes
undo timer realtime-accounting
Default
The real-time accounting interval is 12 minutes.
Views
RADIUS scheme view
Default command level
2: System level
Parameters
minutes: Real-time accounting interval in minutes. The value can be 0 or a multiple of 3, ranging from 3
to 60.
Usage guidelines
For real-time accounting, a NAS must transmit the accounting information of online users to the RADIUS
accounting server periodically. This command sets the interval.
When the real-time accounting interval on the device is 0, the device sends online user accounting
information to the RADIUS accounting server at the real-time accounting interval configured on the server,
or does not send online user accounting information.
94