Ip Pool - HP HSR6600 Command Reference Manual

Views
ISP domain view
Default command level
2: System level
Parameters
minute: Idle timeout period, ranging from 1 to 600 minutes.
flow: Minimum traffic during the idle timeout period in bytes. It ranges from 1 to 10240000 and defaults
to 10240.
Usage guidelines
With the idle cut function enabled for a domain, the device checks the traffic of each online user in the
domain at the idle timeout interval, and it logs out any user in the domain whose traffic during the idle
timeout period is less than the specified minimum traffic.
You can also set the idle timeout period on the server to make the server log out users whose traffic during
the idle timeout period is less than 10240 bytes. However, your setting on the server takes effect only
when you disable the idle cut function on the device.
Examples
# Enable the idle cut function and set the idle timeout period to 50 minutes and the traffic threshold to
1024 bytes for ISP domain test.
<Sysname> system-view
[Sysname] domain test
[Sysname-isp-test] idle-cut enable 50 1024
Related commands
domain

ip pool

Use ip pool to configure an address pool for assigning addresses to PPP users.
Use undo ip pool to delete an address pool.
Syntax
ip pool pool-number low-ip-address [ high-ip-address ]
undo ip pool pool-number
Default
No IP address pool is configured for PPP users.
Views
ISP domain view
Default command level
2: System level
Parameters
pool-number: Address pool number, ranging from 0 to 99.
36