Ssh Client Source - HP HSR6600 Command Reference Manual

Default
An Stelnet client uses the IPv6 address of the interface specified by the route of the device to access the
Stelnet server.
Views
System view
Default command level
3: Manage level
Parameters
interface interface-type interface-number: Specifies a source interface by its type and number.
ipv6 ipv6-address: Specifies a source IPv6 address.
Usage guidelines
To make sure the Stelnet client and the Stelnet server can communicate with each other, and to improve
the manageability of Stelnet clients in the authentication service, HP recommends you to specify a
loopback interface as the source interface.
Examples
# Specify the source IPv6 address as 2:2::2:2 for the Stelnet client.
<Sysname> system-view
[Sysname] ssh client ipv6 source ipv6 2:2::2:2
Related commands
display ssh client source

ssh client source

Use ssh client source to specify the source IPv4 address or source interface of the Stelnet client.
Use undo ssh client source to remove the configuration.
Syntax
ssh client source { interface interface-type interface-number | ip ip-address }
undo ssh client source
Default
An Stelnet client uses the IP address of the interface specified by the route of the device to access the
Stelnet server.
Views
System view
Default command level
3: Manage level
Parameters
interface interface-type interface-number: Specifies a source interface by its type and number.
ip ip-address: Specifies a source IPv4 address.
382