HP HSR6600 Command Reference Manual page 150

Hide thumbs Also See for HSR6600:
Table of Contents

Advertisement

Use undo dot1x port-method to restore the default.
Syntax
In system view:
dot1x port-method { macbased | portbased } [ interface interface-list ]
undo dot1x port-method [ interface interface-list ]
In Ethernet interface view:
dot1x port-method { macbased | portbased }
undo dot1x port-method
Default
MAC-based access control applies.
Views
System view, Ethernet interface view
Default command level
2: System level
Parameters
macbased: Uses MAC-based access control on a port to separately authenticate each user attempting to
access the network. If this method is used, when an authenticated user logs off, no other online users are
affected.
portbased: Uses port-based access control on a port. If this method is used, once an 802.1X user passes
authentication on the port, any subsequent user can access the network through the port without
authentication. When the authenticated user logs off, all other users are logged off.
interface interface-list: Specifies an Ethernet port list, which can contain multiple Ethernet ports. The
interface-list argument is in the format of interface-list = { interface-type interface-number [ to
interface-type interface-number ] } & <1- 1 0>, where interface-type represents the port type,
interface-number represents the port number, and & <1- 1 0> means that you can provide up to 10 ports
or port ranges for this argument. The start port number must be smaller than the end number and the two
ports must be the same type.
Usage guidelines
In system view, if no interface is specified, the command applies to all ports.
Examples
# Configure port GigabitEthernet 3/0/1 to implement port-based access control.
<Sysname> system-view
[Sysname] dot1x port-method portbased interface gigabitethernet 3/0/1
Or
<Sysname> system-view
[Sysname] interface gigabitethernet 3/0/1
[Sysname-GigabitEthernet3/0/1] dot1x port-method portbased
# Configure ports GigabitEthernet 3/0/2 through GigabitEthernet 3/0/5 to implement port-based
access control.
<Sysname> system-view
137

Advertisement

Table of Contents
loading

This manual is also suitable for:

Hp 6600

Table of Contents