Local-Name; Nat Traversal - HP HSR6600 Command Reference Manual

[Sysname-ike-peer-xhy] local-address 1.1.1.1

local-name

Use local-name to configure a name for the local security gateway to be used in IKE negation.
Use undo local-name to restore the default.
Syntax
local-name name
undo local-name
Default
The device name is used as the name of the local security gateway view.
Views
IKE peer view
Default command level
2: System level
Parameters
name: Name for the local security gateway to be used in IKE negotiation, a case-sensitive string of 1 to
32 characters.
Usage guidelines
If you configure the id-type name or id-type user-fqdn command on the initiator, the IKE negotiation peer
uses the security gateway name as its ID to initiate IKE negotiation, and you must configure the ike
local-name command in system view or the local-name command in IKE peer view on the local device.
If you configure both the ike local-name command and the local-name command, the name configured
by the local-name command is used.
The IKE negotiation initiator sends its security gateway name as its ID to the peer, and the peer uses the
security gateway name configured with the remote-name command to authenticate the initiator. Make
sure the local gateway name matches the remote gateway name configured on the peer.
Examples
# Set the name of the local security gateway to localgw in IKE peer view of peer1.
<Sysname> system-view
[Sysname] ike peer peer1
[Sysname-ike-peer-peer1] local-name localgw
Related commands
• remote-name
id-type
•

nat traversal

Use nat traversal to enable the NAT traversal function of IKE/IPsec.
Use undo nat traversal to disable the NAT traversal function of IKE/IPsec.
345