Nas-Backup-Ip - HP HSR6600 Command Reference Manual

<Sysname> system-view
[Sysname] radius scheme radius1
[Sysname-radius-radius1] key accounting ok
# For RADIUS scheme radius1, set the shared key for secure authentication/authorization
communication to $c$3$NMCbVjyIutaV6csCOGp4zsKRTlg2eT3B in cipher text.
<Sysname> system-view
[Sysname] radius scheme radius1
[Sysname-radius-radius1] key authentication cipher
$c$3$NMCbVjyIutaV6csCOGp4zsKRTlg2eT3B
Related commands
display radius scheme

nas-backup-ip

Use nas-backup-ip to specify a backup source IP address for outgoing RADIUS packets in a stateful
failover scenario.
Use undo nas-backup-ip to restore the default.
Syntax
nas-backup-ip ip-address
undo nas-backup-ip
Default
A RADIUS scheme is configured with no backup source IP address for outgoing RADIUS packets.
Views
RADIUS scheme view
Default command level
2: System level
Parameters
ip-address: Backup source IP address for outgoing RADIUS packets. It must be the source IP address for
outgoing RADIUS packets that is configured on the other device for stateful failover and cannot be
0.0.0.0, 255.255.255.255, a class D address, or a class E address.
Usage guidelines
The following matrix shows the command and router compatibility:
Command
nas-backup-ip
With a backup source IP address configured for outgoing RADIUS packets, a device for stateful failover
sends this address to the RADIUS server if it is the active device. When the active device fails, the RADIUS
server can send unsolicited RADIUS packets to the standby device.
A RADIUS scheme can have only one backup source IP address. If you specify a new backup source IP
address for the same RADIUS scheme, the new one overwrites the old one.
6602 HSR6602
Yes No
71
6604/6608/6616
No