Configuring Ospf Interface Parameters - D-Link DI-1750 Reference Manual

(00)beigrp
(01)bgp
(02)ospf
(03)rip Enable Routing Information Protocol(RIP)
Please Input the code of command to be excute(0-3): 2
input 2，Select ospf option ，prompt is as below:
(00)<1-65535>
Please Input the code of command to be excute(0-0): 0
input 0，prompt is as below:
Please input a digital number:Please input a string:
input process-id.
Step2：
In the prompt Select 14 option ，prompt is as below:
(00)A.B.C.D
Please Input the code of command to be excute(0-0): 0
input 0，Select A.B.C.D option ，prompt is as below:
Please input a IP Address:
input IP ，then prompt is as below:
(00)A.B.C.D
Please Input the code of command to be excute(0-0): 0
input 0，Select A.B.C.D option ，prompt is as below:
Please input a IP Address:
input mask ，then prompt is as below:
(00)area
Please Input the code of command to be excute(0-0): 0
input 0，Select area option ，then input

6.11.4 Configuring OSPF Interface Parameters

D-Link OSPF implementation allows you to alter certain interface-specific OSPF parameters, as
needed. You are not required to alter any of these parameters, but some interface parameters must be
consistent across all routers in an attached network.
To specify interface parameters for your network, use the following commands in interface configuration
mode:
ip ospf cost cost
ip ospf
seconds
ip ospf transmit-delay seconds
ip ospf priority number
ip ospf hello-interval seconds
ip ospf dead-interval seconds
ip ospf authentication-key key
Enable BEIGRP (compatible with eigrp)
Enable Border Gateway Protocol (BGP)
Enable Open Shortest Path First (OSPF)
Process ID
Network number
OSPF network mask
Set the OSPF area ID
Command
retransmit-interval
Model Name
area-id.
Function
Explicitly specifies the cost of sending a packet on an
OSPF interface.
Specifies the number of seconds between link-state
advertisement (LSA) retransmissions for adjacencies
belonging to an OSPF interface.
Sets the estimated number of seconds required to send
a link-state update packet on an OSPF interface.
Sets priority to help determine the OSPF designated
router for a network.
Specifies the length of time between the hello packets
that sends on an OSPF interface.
Sets the number of seconds that a device must wait
before it declares a neighbor OSPF router down
because it has not received a hello packet.
Assigns a password to be used by neighboring OSPF
routers on a network segment that is using the OSPF
- 227 -