Interface Configuration - D-Link DI-1750 Reference Manual

3. Interface Configuration

3.1 Overview
By the information in this chapter to understand the types of interfaces supported on D-Link routers and
to search configuration information for various types of interfaces.
For a complete description of the interface commands used in this and other chapters that describe
interface configuration, refer to the "Interface Configuration Command" chapter. To search
documentation of other commands that appear in this chapter, please see the related contents of user
manual.
This chapter contains general information that applies to all interface types; it includes these sections:
3.1.1 Supported types of interface
Please see the following form to obtain correlative information about the type of interface.
Types of Interface
LAN interface
Serial interface
Logic interface
E1 interface
PRI interface
BRI interface
DTU interface
MODEM interface
Two types of interfaces are supported by D-Link router: physical and virtual interfaces. The types of
physical interfaces on a device depend on its standard communication interface and the interface
module equipped on the router. The virtual interfaces that D-Link routers and access servers support
include sub-interface and logic interface. The sub-interface derived from physical interface. Please see
Introduction of sub-interface for more details. The logic interface indicates the interface that created
manually by user and without corresponding physical equipment.
Presently, the physical interfaces supported by D-Link Router that include:
♦ Ethernet
♦ FastEthernet
♦ Synchronous Serial
♦ Low-speed Serial
Model Name
Task
Configure Ethernet interface
Configure FastEthernet interface
Configure Synchronous Serial interface
Configure low-speed Serial interface
Configure Loop-back interface
Configure Empty interface
Configure Dialup interface
Virtual template and virtual access
interface
Multi-link interface
Tunnel interface
Sub-interface
Configure channelized E1 interface
Configure PRI interface
Configure BRI interface
Configure DTU interface
Configure the asynchronous MODEM
interface
- 8 -
Reference information
"Configure LAN interface"
"Configure Serial interface"
"Configure Logic interface"
"Configure E1 interface"
Configure PRI interface
Configure BRI interface
Configure DTU interface
Configure the MODEM interface