D-Link DI-1750 Reference Manual page 255

{ip-address
neighbor
distribute-list access-list-name {in | out }
Step1：
input ip Command，prompt is as below:
(00)access-list Named access-list
(01)as-path BGP as-path access list definition
(02)community-list Community attribute list definition
.......
Please Input the code of command to be excute(0-20): 0
input 1，Select access-list option ，prompt is as below:
(00)extended
(01)standard Standard Access List
Please Input the code of command to be excute(0-1): 1
input 1，Select standard option ，prompt is as below:
(00)WORD Standard Access-list name
Please Input the code of command to be excute(0-0): 0
input 0，Select WORD option ，prompt is as below:
Please input a string:D-Link
input string .
Step2：
input routerCommand，prompt is as below:
(00)beigrp Enable BEIGRP (compatible with eigrp)
(01)bgp Enable Border Gateway Protocol (BGP)
(02)ospf Enable Open Shortest Path First (OSPF)
(03)rip Enable Routing Information Protocol(RIP)
Please Input the code of command to be excute(0-3): 1
input 1，Select bgp option ，prompt is as below:
(00)<1-65535> Local anonymous system number
Please Input the code of command to be excute(0-0): 0
Select 0，prompt is as below:
Please input a digital number:Please input a string:
input autonomous-system value .
Step3：
In the prompt Select 12 option ，prompt is as below:
(00)A.B.C.D IP address of neighbor
Please Input the code of command to be excute(0-0): 0
input 0，Select A.B.C.D option ，then prompt：
Please input a IP Address:
input IP ，prompt is as below:
(00)default-originate
(01)description
(02)distribute-list Distribute list
(03)ebgp-multihop
(04)filter-list AS-path filter list
......
Please Input the code of command to be excute(0-17): 2
input 2，Select distribute-list option ，prompt is as below:
(00)WORD Name of distribute-list
Please Input the code of command to be excute(0-0): 0
input 0，Select WORD option ，prompt is as below:
Please input a string:
input string ，prompt is as below:
(00)in Filter incoming routes
(01)out Filter outgoing routes
Please Input the code of command to be excute(0-1):
Model Name
|
peer-group-name}
Extended Access List
Permit announcement of default route to neighbor
Description of the neighbor
Allow EBGP neighbor not directly connected
Set up a BGP filter.
- 253 -