D-Link DI-1750 Reference Manual page 503

(08)poll-pause-timer
......
Please Input the code of command to be excute(0-16): 8
Input 8，select poll-pause-timer item，display：
(00)<10-10000>
Please Input the code of command to be excute(0-0): 0
Select 0，and input milliseconds。
To retrieve default polling values for these operations, use the def forms of these commands.
14.3.8 Configure an SDLC Interface for Half-Duplex Mode
By default, SDLC interfaces operate in full-duplex mode. To configure an SDLC interface for
half-duplex mode, use the following command in interface configuration mode:
half-datamode
Select 28 item from listing, display:
(00)K
......
(14)simultaneous
......
Please Input the code of command to be excute(0-16): 14
Input 14，select simultaneous item，display：
(00)full-datamode
(01)half-datamode
Please Input the code of command to be excute(0-16): 1
Input 1，chose Half-Duplex Mode
14.3.9 Specify the XID Value
The exchange of identification (XID) value you define on the router must match that of the IDBLK and
IDNUM system generation parameters defined in VTAM on the Token Ring host to which the SDLC
device will be communicating.
Note:
Configuring the XID value will affect the attribute of the interface.If the XID value is configured, it
means that the device connected with the interface is PU 2.0.The configuration of XID value must be
performed after the interface has been shundown.
To specify the XID value, use the following command in interface configuration mode:
sdlc xid address xid
Select 28 item from listing, display:
(00)K
......
(15)xid
......
Please Input the code of command to be excute(0-16): 15
Input 15，select xid item，display：
(00)<1-FE>
Please Input the code of command to be excute(0-0): 0
Input 0，display：
Please input a digital number:Please input a string:
Model Name
the interval of polling the secondary station
Time between polls for each secondary SDLC station(ms)
Command
The size of the sending window
config the SDLC working in full or half-datamode
full datamode
half datamode
Command
The size of the sending window
Specify XID value, which determine Pu type
SDLC Address in Hex
Configure an SDLC interface for half-duplex mode.
Specify the XID value to be associated with the SDLC
station.
- 501 -
Function
Function