D-Link DI-1750 Reference Manual page 206

input 0，Select A.B.C.D option ，prompt is as below:
Please input a IP Address：192.168.1.8 （input network number）
(00)A.B.C.D
(01)<cr>
Please Input the code of command to be excute(0-1): 0
Please input a IP Address:255.255.255.0（input mask ）
6.9.3 Allow Unicast Updates for RIP
Because RIP is normally a broadcast protocol, in order for RIP routing updates to reach nonbroadcast
networks, you must configure the D-Link IOS software to permit this exchange of routing information.
To do so, use the following command in router configuration directory:
neighbor ip-address
Key Word:
Q(quit)
(00)auto-summary Config automatic network number summarization
(01)chinese help message in Chinese
(02)chmem Change memory of system
(03)connect Open a outgoing connection
(04)default restore default configuration
(05)default-information Control distribution of default information
(06)default-metric Set metric of redistributed routes
(07)disconnect Discoonect an existing outgoing network connect ion
(08)distance Set administrative distance
(09)english help message in English
(10)exit exit / quit
(11)filter Set route filter to the networks in routing upd ates
(12)help Description of the interactive help system
(13)history look up history
(14)input-queue Specify input queue depth
(15)interface interface configuration
(16)neighbor Specify a neighbor router
......
Please Input the code of command to be excute(0-29): 16 (Select neighbor option )
(00)A.B.C.D
Please Input the code of command to be excute(0-0): 0
Please input a IP Address:192.168.1.8(input IP )
In addition, to control the set of interfaces with which you want to exchange routing updates, you can
disable the sending of routing updates on specified interfaces by configuring the ip rip passive
command. See the discussion on filtering in the "Filter Routing Information" section in the "Configuring
IP Routing Protocol-Independent Commands" chapter.
6.9.4 Apply Offsets to Routing Metrics
An offset list is the mechanism for increasing incoming and outgoing metrics to routes learned via RIP.
This is done to provide a local mechanism for increasing the value of routing metrics. Optionally, you
can limit the offset list with either an access list or an interface. To increase the value of routing metrics,
use the following command in router configuration mode:
offset-list
number]|*
Network mask
Command
gateway IP address
Command
｛
[interface-type
{in|out}
｝
Model Name
Function
Define a neighboring router with which to exchange
routing information.
Function
Apply an offset to routing metrics.
- 204 -