D-Link DI-1750 Reference Manual page 390

[DEFAULT@Router /config/]#policy-map
Key Word:
U(undo) D(default) Q(quit)
(00)WORD
Please Input the code of command to be excute(0-0): 0
Input 0 and select WORD option, input policy-map name at prompt:
Please input a string:name
Note: Input policy map name here, name is only for example.
Will you excute it? (Y/N):y
Enter the policy configuration directory and output the following optional parameters:
Key Word:
Q(quit)
(00)chinese help message in Chinese
(01)chmem Change memory of system
(02)class config class map in this policy-map
(03)connect Open a outgoing connection
(04)default restore default configuration
(05)disconnect Discoonect an existing outgoing network connection
(06)english help message in English
(07)exit exit / quit
(08)help Description of the interactive help system
(09)history look up history
(10)interface interface configuration
(11)no negate configuration
(13)resume Resume an active outgoing network connection
(14)router routing protocol configuration
(15)show show configuration and status
(16)telnet Open a telnet connection
(17)where display all outgoing telnet connection
Please Input the code of command to be excute(0-17):
After entering policy map configuration mode, you can configure the class map name, bandwidth and
the max number of the queues of the current policy map. In command to configure these, you can use
the command below in policy map configuration mode:
Command
class class-name bandwidth
bandwidth(kbps) [queue-limit
packet-number]
Input 2，select class
Key Word:
U(undo) D(default) Q(quit)
(00)WORD
Please Input the code of command to be excute(0-0): 0
Please input a string:name
Note： Input class map name here, name is only for example.
Key Word:
Q(quit)
(00)bandwidth
Please Input the code of command to be excute(0-0): 0
(00)<8-2000000> Kilo Bits per second
Please Input the code of command to be excute(0-0): 0
Please input a string:100
Note：Input bandwith here, 100 is only for example.
Will you excute it? (Y/N):y
Model Name
map.
policy-map name
Configure the bandwidth and the max number of the
queues of a class map in current policy map.
class-map name
specify bandwidth for this class-map
- 388 -
Purpose