D-Link DI-1750 Reference Manual page 70

Frame-relay local-dlci dlci [cir
speed]
Refer to "configuring DLCI" of the former example.
5.4.7 Configure Static Address Mapping for Subinterfaces
A static map links a specified next-hop protocol address to a specified DLCI.
To configure static mapping, perform one of the following tasks in interface configuration mode:
Command
Frame-relay
ipaddress pvc dlci [broadcast]
Please refer to the "configuring static address mapping" above.
Note:
only one static mapping can be configured for point-to-point interface.
5.4.8 Monitor and maintain the Frame Relay Connections
To monitor Frame Relay connections, perform the following command in configuration mode. For more
detail, please refer to the "commands of configuring Frame-relay".
Command
show interface type number
show frame-relay
show frswitch
DEFAULT@Router /config/]#show
Key Word:
U(undo) D(default)
......
(20)interface
(21)ip
......
Please Input the code of command to be excute(0-49): 20
Key Word:
Q(quit)
......
(02)Serial
(03)Async
Please Input the code of command to be excute(0-3): 2
Please input a interface name:s1/0 （input the interface name）
Will you excute it? (Y/N):y
If you want to show the message of frame-relay mapping or switching :
[DEFAULT@Router /config/]#show
Key Word:
U(undo) D(default)
......
(16)frame-relay
(17)frswitch
......
Please Input the code of command to be excute(0-49): 16 （you can also choose 17 to show 也可选 the
frame-relay switch）
Will you excute it? (Y/N):y
Model Name
Specify DLCI for multipoint subinterface.
[Delete/Create] Define the mapping between a next-hop
(undo) map
protocol address and the DLCI
Display DLCI type and LMI type of Frame Relay.
Display current Frame Relay Mapping.
Display the information of Frame Relay switch.
Q(quit)
interface status and configuration
IP information
Serial interface
Asynchronous interface
Q(quit)
Display Frame Relay state
Display Frame Relay switch state
Purpose
Purpose
- 68 -