D-Link DI-1750 Reference Manual page 246

Create a stub area with area id 36.0.0.0. (Note that the authentication and stub options of the area
router configuration command are specified with separate area command entries, but can be merged
into a single area command.)
♦ Specify the backbone area (Area 0).
Configuration tasks associated with redistribution are as follows:
Redistribute IGRP and RIP into OSPF with various options set (including metric-type, metric, tag, and
subnet).
Redistribute IGRP and OSPF into RIP.
The following is an example OSPF configuration:
interface ethernet 1/0
ip address 192.168.20.81 255.255.255.0
ip ospf password GHGHGHG
ip ospf cost 10
!
interface ethernet 1/1
ip address 192.168.30.81 255.255.255.0
ip ospf password ijklmnop
ip ospf cost 20
ip ospf retransmit-interval 10
ip ospf transmit-delay 2
ip ospf priority 4
!
interface ethernet 1/2
ip address 192.168.40.81 255.255.255.0
ip ospf password abcdefgh
ip ospf cost 10
!
interface ethernet 1/3
ip address 192.168.0.81 255.255.255.0
ip ospf password ijklmnop
ip ospf cost 20
ip ospf dead-interval 80
!
router ospf 192
network 192.168.0.0 255.255.255.0 area 0
network 192.168.20.0 255.255.255.0 area 192.168.20.0
network 192.168.30.0 255.255.255.0 area 192.168.30.0
network 192.168.40.0 255.255.255.0 area 192.168.40.0
area 0 authentication simple
area 192.168.20.0 stub
area 192.168.20.0 authentication simple
area 192.168.20.0 default-cost 20
area 192.168.20.0 authentication simple
area 192.168.20.0 range 36.0.0.0 255.0.0.0
area 192.168.30.0 range 192.42.110.0 255.255.255.0
area 0 range 130.0.0.0 255.0.0.0
area 0 range 141.0.0.0 255.0.0.0
redistribute rip
RIP on netwrok 192.168.30.0
router rip
network 192.168.30.0
redistribute ospf 192
！
Model Name
- 244 -