D-Link DI-1750 Reference Manual page 316

Through configuring multicast static route, you can make the router process RPF examining according
configuration instead of unicast routing table. So multicast messages employs tunnel and unicast
messages do not. Multicast static route only resides in local and won't be advertised or process route
forwarding.
Use the following command in global configure directory to configure multicast static route.
Command
ip mroute source-address
mask rpf-address
number[ distance]
input ip Command，prompt is as below:
(00)access-list
......
(13)mroute
......
Please Input the code of command to be excute(0-25):
input 13，Select option ，prompt is as below:
(00)A.B.C.D Source address
Please Input the code of command to be excute(0-0): 0
input 0，Select option ，prompt is as below:
Please input a IP Address:
input address ，prompt is as below:
(00)A.B.C.D Network mask
Please Input the code of command to be excute(0-0): 0
input 0，Select option ，prompt is as below:
Please input a IP Address:
input mask ，prompt is as below:
(00)A.B.C.D RPF neighbor address
Please Input the code of command to be excute(0-0): 0
input 0，Select option ，prompt is as below:
Please input a IP Address:
input address ，prompt is as below:
(00)interface-name
Please Input the code of command to be excute(0-0): 0
input 0，Select option ，prompt is as below:
Please input a interface name:
input name,prompt is as below:
(00)<0-255> Administrative distance for mroute
(01)<cr>
Please Input the code of command to be excute(0-1):
Select parameter .
Model Name
Configure multicast static route.
type
Named access-list
Configure static multicast routes
- 314 -
Purpose
13