D-Link DI-1750 Reference Manual page 99

ctrl-p
Clr
5.6.9 Customerize Local X.3 Parameter
To set an X.3 PAD parameter from a local terminal, use the following commands beginning in EXEC
mode or User mode:
pad address
Ctrl-p
par
set parameter-number: new-value
par
[DEFAULT@Router /enable/]#pad
Key Word:
U(undo) D(default)
(00)svc
(01)pvc
Please Input the code of command to be excute(0-1): 1 （you could also input 0 to configure the pvc）
Key Word:
Q(quit)
(00)WORD
Please Input the code of command to be excute(0-0): 0
Please input a string:1234 (input the x121 address)
Key Word:
Q(quit)
(00)<0-31>
(01)<cr>
Please Input the code of command to be excute(0-1): 1
Will you excute it? (Y/N):y
5.6.10 Monitor X.25 PAD Connection
To display currently opened connecting information, use the following EXE mode command:
Show x25
[DEFAULT@Router /config/]#show
Key Word:
......
(47)x25
(48)x25switch
(49)x29
Please Input the code of command to be excute(0-49): 47
Key Word:
Q(quit)
(00)tcp
(01)vc
Command
Command
Q(quit)
pad to the remote x121 address
pad to the remote through pvc
X.121 address
X29 pad profile number
Command
Display X.25 state
Show X.25 switch route table
Show X.29d X3 pad parameters
Show X25-TCP State
Display X.25 state
Model Name
Purpose
From the remote host, escape back to the local
router PAD mode.
Clear the virtual call.
Purpose
Enter X.28 mode.
From X.28 mode escape back to PAD mode.
Display the current X.3 PAD parameters.
Change the value of a parameter.
Verify that the new PAD parameter was set
correctly.
Purpose
To display currently opened X.25 connecting
information.
- 97 -