D-Link DI-1750 Reference Manual page 13

Command
bandwidth kilobps
Choose the item 1 of prompt and set the bandwidth.
The bandwidth is only a parameter of route that did not affect the communication rate of actual physical
interface.
3.4.2 Set timing delay
The information of timing delay is used to carry out the operational decision by upper layer protocol
(ULP). Following commands set the timing delay in the current interface:
Command
delay tensofmicroseconds
Choose the item 8 of prompt and set the delay.
The setting of timing delay is only set a parameter of information. This configuration command cannot
adjust the actual timimg delay of interface.
Each interface has a default maximum packet size or maximum transmission unit (MTU) size. This
number generally defaults to 1500 bytes. On serial interfaces, the MTU size varies, but cannot be set
smaller than 68 bytes. To adjust the maximum packet size, use the following command in interface
configuration mode:
Command
Mtu bytes
Choose the item 20 of prompt and set the value of MTU.
Supervise and maintain the interface
To supervise and maintain the interface by the tasks below:
Examine status of interface
D-Link Router supports the command that to display various information of interface, which is include
the status of interface and version of hardware and software. Parts of interface supervising commands
are listed in the form below. Please see the "Command of interface configuration" for details.
Use following commands:
Command
show interface [type slot/port]
show running-config
show version
To display interface status, input the command "show" to list all the parameters in global configuration
contents:
(00)alias
......
(19)interface
......
Please Input the code of command to be excute(0-45): 19
Input 19, choose the item "interface" and it will prompt:
(00)FastEthernet
Set the bandwidth for current configured interface
Set the timing delay for current configured interface
Set MTU for current configured interface
Display the status of interface
Display current configuration
Display setting of hardware, version of software, filename of
configuring file, source image and boot image.
alias for command
interface status and configuration
FastEthernet interface
Model Name
Purpose
Purpose
Purpose
Purpose
- 11 -