D-Link DI-1750 Reference Manual page 98

Prof filename
Reset
Set
set?
Stat
Quit
5.6.7 Place a Call
you need to designate the X.121 address of information destination to setup a call with it.Perform the
following commands in user mode or management mode:
pad svc address [profile-number
[r|w]]
pad pvc
[profile-number [r|w]]
SVC section：
[DEFAULT@Router /enable/]#pad
Key Word:
U(undo) D(default)
(00)svc
(01)pvc
Please Input the code of command to be excute(0-1): 1 （you can also input 0 to set pvc）
Key Word:
Q(quit)
(00)WORD
Please Input the code of command to be excute(0-0): 0
Please input a string:1234 (input the x121 address)
Key Word:
Q(quit)
(00)<0-31>
(01)<cr>
Please Input the code of command to be excute(0-1): 0
Please input a string: 5 （input profile number）
Key Word:
Q(quit)
(00)r
(01)w
Please Input the code of command to be excute(0-1): 0
Key Word:
Q(quit)
(00<cr>
Please Input the code of command to be excute(0-0): 0
Will you excute it? (Y/N):y
5.6.8 Clear a Call
After you connect to a remote X.25 device, you can clear the connection by using the following
commands :
Load a standard profile.
Reset the call.
Change the local values of parameters.
Changes and then read the values of parameters.
Requests status of a connection.
Exit PAD connection.
Command
interface pvc#
Q(quit)
pad to the remote x121 address
pad to the remote through pvc
X.121 address
X29 pad profile number
X29 pad profile read-only
X29 pad profile read-write
Model Name
Purpose
Call a remote interface through SVC. If succeed,
then enter the X.28 mode and display the ">"
prompt.
Call a remote interface through PVC. If
connected,
then enter the X.28 mode and display the
">"Prompt.
- 96 -