D-Link DI-1750 Reference Manual page 66

Please Input the code of command to be excute(0-32): 15
Key Word:
U(undo) D(default)
(00)cir
(01)intf-type
......
Please Input the code of command to be excute(0-10): 1
Key Word:
Q(quit)
(00)dte
(01)dce
(02)nni
Please Input the code of command to be excute(0-2): 1
Will you excute it? (Y/N):y
For an example of how to configure a DTE device or DCE switch, see the section "Hybrid DTE/DCE
PVC Switching Example" later in this chapter.
For an example of how to configure NNI support, see the section "Example of configuration about DCE
interface supported Frame Relay switch" later in this chapter.
5.4.2 Specify the Static Route
Perform the following command in interface configuration mode to specify the route for PVC switching:
Command
Frswitch (undo) in-port in-dlci
out-port out-dlci
[DEFAULT@Router /config/]#frswitch
Key Word:
U(undo) D(default)
(00)Serial
Please Input the code of command to be excute(0-0): 0
Please input a interface name:s1/1 （input the interface name）
Key Word:
Q(quit)
(00)nnnn
Please Input the code of command to be excute(0-0):0
Please input a string:100 （input the PVC number）
Key Word:
Q(quit)
(00)Serial
Please Input the code of command to be excute(0-0): 0
Please input a interface name:s1/2 （input the interface name）
Key Word:
Q(quit)
(00)nnnn
Please Input the code of command to be excute(0-0): 0
Please input a string:200 （input the PVC number）
Will you excute it? (Y/N):y
For an example of how to specify a static route, see the section "Example of configure Frame Relay
switch" later in this chapter.
5.4.3 Disable or Reenable Frame Relay Inverse ARP
Frame Relay Inverse ARP is a method of searching DLCI protocol address in Frame Relay networks.
Model Name
Q(quit)
Set committed information rate
Set interface mode for Frame Relay(DTE/DCE/NNI)
Set interface mode to FR DTE
Set interface mode to FR DCE
Set interface mode to FR NNI
[Delete/Configure]static route of PVC.
Q(quit)
Serial interface
PVC number
Serial interface
PVC number
Purpose
- 64 -