D-Link DI-1750 Reference Manual page 86

(00)<1-15>
Please Input the code of command to be excute(0-0): 0
Please input a string:15
Key Word:
Q(quit)
(00)Async
(01)Serial
Please Input the code of command to be excute(0-1): 1
Please input a interface name:s1/1 (input the interface name)
Key Word:
Q(quit)
(00)<1-15>
Please Input the code of command to be excute(0-0): 0
Please input a string:13
Will you excute it? (Y/N):y
The two connected interface must have valid PVC(permanent virtue circuit) if user want to configure the
switching table.
5.5.14 Configure SVC switching between X.25 interface
The window size and packet length of the host that switch through the D-LINK router can be different,
they can be negotiated the minimum value.
Use the following command in configuration mode:
x25switch
destination [x121addr/default] port
[DEFAULT@Router /config/]#x25switch
Key Word:
U(undo) D(default)
(00)connect
(01)destination
(02)xot
Please Input the code of command to be excute(0-2): 1
Key Word:
Q(quit)
(00)x121addr
Please Input the code of command to be excute(0-0): 0
Please input a string:123456 (input the x121 address)
Key Word:
Q(quit)
(00)Serial
Please Input the code of command to be excute(0-0): 0
Please input a interface name:s1/0 (input the interface name)
......
5.5.15 configuring the XOT switching between X.25 interfaces
D-LINK router can implement the X.25 datagram switching basing on the TCP/IP.
Use the following command in configuration mode:
x25switch
local-interface
remote-interface
remote-ip-address [source interface]
PVC number
Async interface
Serial interface
PVC number
Command
(undo/default)
Q(quit)
Add/delete a PVC route in X.25 switch table
Add/delete a SVC route in X.25 switch table
Configure X25 over TCP route in X.25 switch table
X.121 address
Serial interface
Command
(undo) xot pvc
local-pvc
remote-pvc
Model Name
Purpose
Set a SVC interface addressing
Purpose
Set a PVC XOT interface addressing
- 84 -