D-Link DI-1750 Reference Manual page 439

Will you excute it? (Y/N):y
10.5.7 Specify the threshold value of the dialer rotary group
After the threshold value is specified, DDR will monitor the flow of the interface. When the flow exceeds
the threshold and there is an usable interface in the dialer group, the interface will be turned on to add
the bandwidth of the dialer group. When the flow under the threshold, the redundant interfaces will be
disconnected automatically. If the physical interface is configured priority, the interface turned on or
disconnected is determined according to the priority. The highest priority interface will be chosen when
the interface is active, and lowest priority interface will be chosen when the interface is inactive.
Specify the threshold value of the dialer rotary group
dialer load-threshold enable-threshold disable-threshold
Key Word:
U(undo) D(default) Q(quit)
(00)called Dialer called string
(01)caller Dialer caller string
(02)enable-timeout Set time interval between line down and dialing
(03)fast-idle Set idle time when line contention
(04)hold-queue Set output hold queue length
(05)idle-timeout Set idle time before disconnecting line
(06)load-threshold Specify threshold for placing additional calls
(07)map Define multiple dial-on-demand numbers
(08)remote-name Specify remote name
(09)rotor Set outbound rotor order
(10)string Set default telephone number
(11)wait-for-carrier-time Set the router wait for carrier time
Please Input the code of command to be excute(0-11): 6（select option load-threshold）
Key Word:
Q(quit)
(00)<0-100> Load threshold to place another call
Please Input the code of command to be excute(0-0): 0
Input 0，select option <0-100>
Please input a digital number:3
Note：input the active threshold value here,for example 3
Key Word:
Q(quit)
(00)<0-100> Load threshold to disconnect a call
Please Input the code of command to be excute(0-0): 0
input 0，select option <0-100>
Please input a digital number:2
Note：input the inactive threshold value here,for example 2.
Will you excute it? (Y/N):y
10.5.8 Specify the dtr method as the dialer method
You can directly activate the dialer when the DTR signal is valid in the DTE.
Specify the dtr as the dialer method
dialer dtr
(00)called Dialer called string
(01)caller Dialer caller string
(02)dtr Set DTR dialing for interface
(03)enable-timeout Set time interval between line down and dialing
(04)fast-idle Set idle time when line contention
(05)hold-queue Set output hold queue length
(06)idle-timeout Set idle time before disconnecting line
Model Name
- 437 -