D-Link DI-1750 Reference Manual page 50

Please Input the code of command to be excute(0-36): 36
Key Word:
U(undo)
(00)<0-256>
Please Input the code of command to be excute(0-0): 0
Please input a digital number:132 （input Number of characters）
Will you excute it? (Y/N):y
Key Word:
Q(quit)
......
(15)length
(16)line
......
Please Input the code of command to be excute(0-36): 15
Key Word:
U(undo)
(00)<0-512>
Please Input the code of command to be excute(0-0): 0
Please input a digital number:40 （input Number of lines）
Will you excute it? (Y/N):y
2. Following configuration set s1/0 as TTY port.
Key Word:
Q(quit)
......
(25)pdp
(26)physical-layer
......
Please Input the code of command to be excute(0-34): 26
Key Word:
U(undo)
(00)flow-control
(01)mode
(02)sampling
(03)speed
Please Input the code of command to be excute(0-3): 1
Key Word:
Q(quit)
(00)async
(01)sync
Please Input the code of command to be excute(0-1): 0
Will you excute it? (Y/N):y
In this configuration, the straight back-to-back cable connected with s1/0 port. If the connection is
remote access through Modem, line dial should be configured before the command config-async mode
interactive.
4.3.3 Example of VTY configuration
All the limitation of VTY screen output lines will be canceled by following configuration, prompt more
will disappear.
[DEFAULT@Router /config/]#line
Key Word:
U(undo) D(default)
(00)aux
(01)console
(02)tty
(03)vty
D(default) Q(quit)
Number of characters on a screen line(0 for no line wrap)
Set number of lines on a screen
Configure a terminal line
D(default) Q(quit)
Number of lines on screen (0 for no pausing)
D(default) Q(quit)
Flow control
Configure sync or async physical layer on serial interface
set clock sampling mode
port speed
asynchronous mode
synchronous mode
Q(quit)
Auxiliary line
Primary terminal line
Terminal controller
Virtual terminal
Model Name
pdp configuration commands
Configure physical layer parameters
- 48 -