Table of Contents
Advertisement
Model Name
3660_1_config_dialpeer#port 1/0
3660_1_config_dialpeer#exit
3660_1_config#dial-peer voice 2 voip
3660_1_config_dialpeer#destination-partten 10....
3660_1_config_dialpeer#session target ipv4: 10.1.2.2
3660_1_config_dialpeer#exit
3660_1_config#
3660_2 configure：
3660_2_config#inter e1/0
3660_2_config_e1/0#inter e1/0
3660_2_config_e1/0#ip address 10.1.1.2 255.255.255.0
3660_2_config_e1/0#exit
3660_2_config#voice-port 1/0
3660_2_config_voiceport#type 5
3660_2_config_voiceport#operation 4-wire
3660_2_config_voiceport#emsignal-in immediate
3660_2_config_voiceport#emsignal-out delay-dial
3660_2_config_voiceport#exit
3660_2_config#dial-peer voice 1 pots
3660_2_config_dialpeer#destination-partten 10
3660_2_config_dialpeer#port 1/0
3660_2_config_dialpeer#exit
3660_2_config#dial-peer voice 2 voip
3660_2_config_dialpeer#destination-partten 20....
3660_2_config_dialpeer#session target ipv4: 10.1.1.2
3660_2_config_dialpeer#exit
3660_2_config#
12.7.5 Configure dialing replacer
Layout：Dial 1234，if failed，configure replace order：2345，3456
Configure command：
Router_config#dial-peer voice 10 voip
Router_config_dialpeer#destination 1234
Router_config_dialpeer#session target ras
Router_config_dialpeer#alternative 20 preference 0
Router_config_dialpeer#alternative 21 preference 2
Router_config_dialpeer#ex
Router_config#dial-peer voice 20 voip
Router_config_dialpeer#destination 2345
Router_config_dialpeer#session target ras
Router_config_dialpeer#ex
Router_config#dial-peer voice 21 voip
Router_config_dialpeer#destination 3456
Router_config_dialpeer#session target ras
Router_config_dialpeer#ex
You can use dialpeers with the same number to be replacer, but as configuring, you must arrange the
primary dialpeer in the front and the replaced dialpeer in the behind. (You can use command show
running to examine it.) Because it is processed in turn of arrangement and according to the rule of first
matching first using when processing dialing query. So we suggest you first configure primary dialpeer
and then configure replacing dialpeer, or in layout configure the replacing dialpeer ID to be larger than
primary dialpeer and use the command in global configure mode to align dialpeers by ID.
Note ：
The phone number configured in dialpeer used by replacer must be available number, viz. there is no dot or letter T.
Command aline-dialpeer is non-resumable, please use it after perfect layout.
- 472 -
Hide quick links:
Advertisement
Table of Contents
