D-Link DI-1750 Reference Manual page 136

(29)set_e1_threshold
(30)show
(31)shutdown
(32)snmp
Please Input the code of command to be execute(0-32): 18
Current Status:b3/2
Key Word:
U(undo) D(default) Q(quit)
(00)access-group
(01)address
(02)beigrp
(03)directed-broadcast Enable forwarding IP directed broadcasts Packets
(04)dvmrp
(05)fast-switch
(06)helper-address
(07)igmp
(08)irdp
(09)mask-reply
(10)mroute-cache
(11)mtu
(12)multicast
(13)nat
(14)olnk
(15)ospf
(16)pim-dm
(17)pim-sm
(18)policy
(19)proxy-arp
(20)redirects
(21)rip
(22)route-cache
(23)rsvp
(24)rtp
(25)tcp
(26)unnumbered
(27)unreachables
Please Input the code of command to be execute(0-27): 1
Current Status:s3/2:15
Key Word:
Q(quit)
(00)A.B.C.D IP address
(01)negotiated IP address set by PPP or by DHCP
Please Input the code of command to be execute(0-1): 0
Please input an IP Address Parameter:6.0.0.3
Current Status:b3/2
Key Word:
Q(quit)
(00)A.B.C.D IP netmask
Please Input the code of command to be execute(0-0): 0
Please input an IP Address Parameter:255.0.0.0
Current Status:s3/2:15
Key Word:
Q(quit)
(00)secondary Set this IP address as a secondary address
(01)<cr>
Please Input the code of command to be execute(0-1): 1
Will you execute it? [Y]:
Model Name
SET E1 THRESHOLD
show configuration and status
Shutdown the current interface
Modify SNMP interface parameters
Current Directory: config
Specify IP packet access control group
IP address
Enhanced Interior Gateway Routing Protocol
Enable distance vector multicast-routing protocol.
Fast-Switch interface commands
Specify the destination address to relay UDP broadcast
s
Igmp interface command
Configure ICMP Router Discovery Protocol
Enable reply ICMP Mask request message
Enable using mroute-cache for forwarding multicast pac
kets
Maximum Transmission Unit
Configure ip multicast parameter
NAT interface configuration commands
start IGMP only-link on this interface
set OSPF parameter for this port
PIM Dense Mode, interface commands
Enable PIM protocol sparse mode
Enable policy routing
Enable proxy ARP
Enable sending ICMP Redirect messages
Set RIP parameter on interface
Enable fast-switching cache for outgoing packets
RSVP interface command
Rtp parameters
Tcp parameters
Enable IP use unnumbered address
Enable sending ICMP Unreachable messages
Current Directory: config
Current Directory: config
Current Directory: config
- 134 -