D-Link DI-1750 Reference Manual page 331

To enable/disable DVMRP summarization, use the following command in interface configuration state:
[no] ip dvmrp auto-summary
[no]
ip
network-address network-mask
In parameter clew choose the 4th option, clew:
(00)access-group
......
(04)dvmrp
......
Please Input the code of command to be excute(0-22): 4
Input 4，choose DVMRP option.clew:
(00)advert-metric
(01)auto-summary
......
Input 1，choose auto-summary option.
7.5.4 For interface to act as leaf
Force DVMRP to ignore other routers on this interface. DVMRP will never send or accept neighbor
probes or route reports on this interface.
Use the command in interface configure state:
[no ]ip dvmrp force-leaf
In parameter clew choose the 4th option, clew:
(00)access-group
......
(04)dvmrp
......
Please Input the code of command to be excute(0-22): 4
Input 4，choose DVMRP option.clew:
(00)advert-metric
(01)auto-summary
(02)default-information
(03)force-leaf
......
Input 3，choose force-leaf option.
7.5.5 Configure filter in a interface
To filter any specified routes, use the command in supervise state.
[no] ip dvmrp route-filter {in|out}
acl-name
In parameter clew choose the 4th option, clew:
(00)access-group
......
Command
Enable the automatic summarization.
Specifies a DVMRP summary address.
summary-address
Specify access control for packets
Enable distance vector multicast-routing protocol.
advertising metric out of the interface
auto summary
Command
配置端口为叶节点.
Specify access control for packets
Enable distance vector multicast-routing protocol.
advertising metric out of the interface
auto summary
default route report in the interface
force leaf
Command
Filter any routes received from the interface using the IP
standard access list.
Specify access control for packets
Model Name
Function
Function
Function
- 329 -