D-Link DI-1750 Reference Manual page 121

......
(07)multilink
(08)pap
(09)timeout
Please Input the code of command to be excute(0-9): 7
Will you excute it? (Y/N):y
To configure the BRI interfaces to belong to the dialer rotary group, use the following commands
beginning in global configuration mode:
Command
interface bri number
ip (undo) addr
encapsulation ppp
dialer idle-timeout seconds
dialer rotary-group number
dialer load-threshold load
[DEFAULT@Router /config/]#interface......
(03)AsyncAsynchronous interface
(04)BRIISDN Basic Rate Interface......
Please Input the code of command to be excute(0-11):4
Please input a interface name:b2/0（input interface name）
Will you excute it? (Y/N):y
Key Word:
U(undo)
......
(19)ipIP configuration commands
(20)mtuSet the interface MTU
......
Please Input the code of command to be excute(0-32):19
Key Word:
U(undo) D(default)
(00)access-groupSpecify access control for packets
addressIP address
beigrpEnhanced Interior Gateway Routing Protocol
......
Please Input the code of command to be excute(0-18):1
(00)A.B.C.DIP address
negotiatedIP address negotiated over PPP or via DHCP
Please Input the code of command to be excute(0-1):0
Please input a IP Address:192.168.1.1 255.255.255.0(input ip address)
secondaryMake this IP address a secondary address
(01)<cr>
Please Input the code of command to be excute(0-1):1
Will you excute it? (Y/N):y
Key Word:
U(undo) D(default)
......
(12)encapsulation
(13)English
......
Please Input the code of command to be excute(0-32):12
Key Word:
U(undo) D(default)
(00)ppp PPP Protocol
Please Input the code of command to be excute(0-0):0
Model Name
Make interface multilink capable
Set PAP authentication parameters
Set PPP timeout parameters
Specifies an interfaces.
Do not configure IP address
Enable PPP encapsulation
(Optional)Sets the dialer idle timeout period
Adds the interface to the dialer rotary group.
Configure the maximum load threshold of dialer
D(default)
Q(quit)
Q(quit)
Set encapsulation type for an interface
help message in English
Q(quit)
- 119 -
Purpose
Q(quit)