15.1.4 protocol binding
VPDN group must bind with relative protocol, for this product, only L2TP protocol is enabled, the
following command can bind VPDN group and protocol:
Protocol protocol-type
Protocol(undo) protocol-type
The example below creates a VPDN group and binds VPDN group and L2TP protocol.
First enter the vpdn-group 1 with command "vpdn-group 1"(see the example of command vpdn-group)
Then, configure the "protocol l2tp" just as below.
Current Status:vpdn Current Directory: config
Key Word:
Q(quit)
(00)accept_dialin VPDN accept-dialin group configuration
(01)chmem Change memory of system
(02)controller controller configuration
(03)domain Initiate a tunnel based on domain name
(04)exit exit / quit
(05)force-local-chap Force a CHAP challenge to be instigated locally
(06)help Description of the interactive help system
(07)hotkey ctrl+\ :print system information , ctrl+] :reb
oot
(08)initiate-to Initiate tunnel to remote peer
(09)interface interface configuration
(10)l2tp L2TP specific commands
(11)lcp-renegotiation force LCP negotiate locally
(12)local-name Local name used for group authentication
(13)pptp PPTP specific commands
(14)protocol Tunneling protocol to be used
(16)request-dialin VPDN request-dialin group configuration
(17)router routing protocol configuration
(19)set_e1_threshold SET E1 THRESHOLD
(20)show show configuration and status
(21)terminate-from Terminate tunnel from remote peer
(22)virtual-template Virtual template to clone from
(23)vlan Vlan commands
Please Input the code of command to be execute(0-23): 14
Current Status:vpdn Current Directory: config
Key Word:
U(undo) Q(quit)
(00)l2tp Layer 2 Tunneling Protocol
(01)pptp Point to Point Tunneling Protocol
Please Input the code of command to be execute(0-1): 0
Will you execute it? [Y]:y
15.1.5 set LAC domain name
LAC will not response until LAC OPEN request user name in certain VPDN group domain, afterwards,
sending SCCRQ information, user name should include '@'division symbol, the character after '
@'is user domain name, the following command can set NAC domain name:
Domain domain_name
domain(undo) domain-name
Command
Command
Model Name
Binding VPDN group and protocol.
Cancle VPDN group and protocol.
Set NAC domain name.
Cancle NAC domain name.
- 508 -
Function
function