D-Link DI-1750 Reference Manual page 340

Please input a interface name:a0/0 （输入端口名称，此处仅为示例）
Will you excute it? (Y/N):y
Key Word:
Q(quit)
......
(27)ppp
(28)priority-group
......
Please Input the code of command to be excute(0-35): 27
Key Word:
U(undo)
(00)authentication
(01)authorization
......
Please Input the code of command to be excute(0-9): 0
(00)chap
(01)ms-chap
(02)pap
Please Input the code of command to be excute(0-2): 0
(00)WORD
(01)callin
......
Please Input the code of command to be excute(0-5): 0
Please input a string:async0 （Input the same authentication list name with the above）
Will you excute it? (Y/N):y
In this example, "async0" is the name of the method list, and the protocols included in this method list
are listed after the name in the order in which they are to be performed. After the creation of method
list, the list will be applied on the appropriate port. Note that the method list name in a aaa
authentication command must match that in the ppp authentication command.
8.1.5 General Configuration Process of AAA Authentification
To configure AAA authentication, you need to finish the following configuration process:
If you are using a security server, please configure the security protocol parameters, like RADIUS and
TACACS.
Define the authentication methods list with aaa authentication command.
Apply the methods list to a specific port or line if necessary.
8.1.6 AAA Authentication Methods Description
1. Use AAAConfiguration Login Authentication
The AAA security service facilitates a variety of login authentication methods. You will have to start
AAA authentication with aaa authentication command using whatever login method. Creat one or
more lists of authentication methods in aaa authentication login command, used in login. These lists
are applied with the circuit configuration command login authentication. When configuring, please
use the commands below, starting from the global configuration directory:
aaa (default) authentication login
{list-name}method1 [method2...]
line [aux | console | tty | vty]
line-number [ending-line-number]
login (default)
{list-name}
D(default) Q(quit)
Set PPP link authentication method
Set PPP network authorization method
Challenge Handshake Authentication Protocol (CHAP)
Microsoft Challenge Handshake Authentication Protocol(MS-CHAP)
Password Authentication Protocol (PAP)
Use an authentication list with this name
Authenticate remote on incoming call only
Command
authentication
Model Name
Point-to-point protocol
Assign a priority group to interface
Purpose
Create a global authentication list
Enter the config mode of a certain line
Apply the authentication list to one or more lines
- 338 -