D-Link DI-1750 Reference Manual page 467

dial-peer voice num pots
To configure the identified POTS peer, use the following commands in dial-peer configuration mode:
Command
destination-pattern STR[T]
port slot/port
trim_prefix number
12.4.7 Configure VoIP Dial Peers
To configure a VoIP peer, you need to uniquely identify the peer (by assigning it a unique tag number),
define its destination telephone number and destination IP address. To enter the dial-peer configuration
mode, use the following command in global configuration mode:
Command
dial-peer
num voip
To configure the identified VoIP peer, use the following commands in dial-peer configuration mode:
destination-pattern STR[T]
Session target {ipv4: ip_addr | terminal |
ras}
codec codec_type
trim_prefix number
Command
Define the phone number concerned with POTS dial-peer.
Associate the special voice port with POTS dial-peer.
This command has different meaning in different course.
In POTS peers, if local called port is FXO port, the process will peel off the
first few numbers automatically and dial left numbers to PBX automatically.
Refer to the presentation of VOIP peers below for meaning of VOIP peers.
Enter the dial-peer configuration mode to configure a VoIP peer. The
voice
number value of the dial-peer voice voip command is a tag that uniquely
identifies the dial peer.
Command
Model Name
Function
Enter the dial-peer configuration mode to
configure a POTS peer. The num value of the
command is a tag that uniquely identifies the
dial peer.
Function
Function
Define the destination telephone number associated with this
VoIP dial peer. The string argument is telephone number with
the length less than 15, which include the wildcard "."
Destination-address specifies destination IP address for the
dial peer.
Terminal indicates that the set-dial-peer is used to call H.323
terminal device such as Microsoft Netmeeting. Here the
config-destination-pattern command is used to mark the IP
address of H.323 terminal device. The format likes A.B.C.D.
After dots are taken out, 0 is paded in each field less than
3-bit. If the config-trim-prefix command is configured, get rid
of the appointed prefix and examine IP address according
upper rule.
Ras indicates that the destination address information bound
by the set-dial-peer can be got through RAS dynamic parsing.
Configure all the codec for the dialog. codec_type:
{g711ar64 | g711ur64 | g729r8 | g729-compatible |
g723r53 | g723r63 | g726r32 | g726r40 | g727r32 | g727r40 }
This command has different meanings in different course.
In VOIP dial-peer, this command is meaningful when session
terminal is configured. And the meaning is that the first few
numbers input by user will be peeled off and the left numbers
will be examined into destination IP address.
- 465 -
Function