D-Link DI-1750 Reference Manual page 28

(02)Serial
Please Input the code of command to be execute(0-11): 2
Please input slot/port:2/0:0
Will you execute it? [Y]:y
Key Word:
(09)encapsulation
Please Input the code of command to be execute(0-28): 9
Current Status:s2/0:0
Key Word:
U(undo) D(default) Q(quit)
(00)frame-relay Frame Relay Protocol
(01)hdlc
(02)ppp
(03)sdlc
(04)x25
Please Input the code of command to be execute(0-4):00
Will you execute it? [Y]:y
Current Status:s2/0:0
Key Word:
Q(quit)
(15)ip
Please Input the code of command to be execute(0-26): 15
(01)address
Please Input the code of command to be execute(0-27): 01
Current Status:s2/0:0
Key Word:
Q(quit)
(00)A.B.C.D
(01)negotiated
Please Input the code of command to be execute(0-1): 00
Please input an IP Address Parameter:130.130.0.1
Current Status:s2/0:0
Key Word:
Q(quit)
(00)A.B.C.D
Please Input the code of command to be execute(0-0): 00
Please input an IP Address Parameter:255.255.255.0
Current Status:s2/0:0
Key Word:
Q(quit)
(00)secondary
(01)<cr>
Please Input the code of command to be execute(0-1): 01
Will you execute it? [Y]:y
8. Configure Tx FIFO of E1 module in UNFRAME mode
When the channel of E1 module worked in UNFRAME mode, the user can change the size of the E1
channel's Tx FIFO to use PCI more effective.The base rule is that the more E1 modules the less Tx
FIFO size.The range of it is from 1 to 63.The default Tx FIFO size is 8.Only NM-1CE1 , NM-2CE1 and
NM-4CE1 support the command.
3.9 Configuring the PRI interface
3.9.1 Introduction of PRI interface
PRI interface is a kind of ISDN interface which consists of 30 B channels plus a singled channels..
The number of the B channel of our PRI interface is not fixed as 30 but can be set by user to meet their
requirement. You can generate and delete the PRI interface through the E1 interface, it's dynamic. You
Serial interface
Set encapsulation type for an interface
Current Directory: config
HDLC Protocol
PPP Protocol
SDLC Protocol
X.25 Protocol
Current Directory: config
IP configuration commands
IP address
Current Directory: config
IP address
IP address set by PPP or by DHCP
Current Directory: config
IP netmask
Current Directory: config
Set this IP address as a secondary address
Model Name
- 26 -