D-Link DI-1750 Reference Manual page 48

4.2.5 Example of CDP configuration
1. Enable CDP function
[DEFAULT@Router /config/]# pdp run
[DEFAULT@Router /config/]# int f0/0
[DEFAULT@Router /f0/0/]# pdp enable
configuring the CDP message interval and message holdtime
[DEFAULT@Router /config/]# pdp timer 30
[DEFAULT@Router /config/]# pdp holdtime 90
monitoring CDP message
[DEFAULT@Router /enable/]# show pdp neighbors
Capability Codes:R - Router, T - Trans Bridge, B - Source Route Bridge S - Switch, H -
Host, I - IGMP, r - Repeater
Device ID Local IntrfceHoldtmeCapabilityPlatform Port ID
joeEth 0 133 4500 Eth 0
samEth 0 152 R AS5200 Eth 0
4.3 Directory of VTY configuration
4.3.1 Introduction of VTY configuration
D-Link Router utilize command line to configure the terminal parameter in simple and agile. The
process of configuration coincides with the habit of user. The setting of width and height can be
displayed to terminal in command line.
1. Software configuration
In this section, we will introduce how to configure pseudo terminal. Please see the chapter "VTY
command" to get more configuring commands of pseudo terminal.
2. Configuring task
D-Link Router has four types of circuit: console, auxiliary, asynchronization and virtual terminal circuit.
The different Router has different amount of above-mentioned circuit. Following are references about
correctly configure the software and hardware.
Type
CON(CTY)
AUX
TTY
VTY
Interface
Console Use for login the Router
and configuring.
RS-232 DTE port is use
for backup asynchronous
Assistant port (TTY) and cannot be
use
console port.
This
interface. Usually use for
dialup converstation with
SLIP and PPP remote
contact.
asynchronization
Use for connect to Telnet,
Virtual
X.25 PAD, HTTP and
asynchronization
Rlogin of synchronous
Model Name
Description
Number 0
Number: less than (or equal to) 4 slots is 65.
Otherwise, it is accounted as the number slot
multiplied by 16 and then adds one.
as the second
is asynchronous Start number is 1. The amount of number will
change with variation of platform. The range
of
interfaces
example, No. 1 slot has 16 asynchronous
modules, No. 2 slot is empty, and No. 3 has 8
synchronous
correspond to line 1, a1/15 correspond to line
16,s3/0 correspond to line 17 and s3/7
correspond to line 24.
The 64 numbers that form maxium number of
TTY circuit and add one.
- 46 -
Rule of circuit numbering
number is maxium
that Router supported.
modules. Thus,
asynchronous
For
a1/0