D-Link DI-1750 Reference Manual page 55

Please Input the code of command to be excute(0-0): 0
Please input a string:100 (input index number)
Key Word:
Q(quit)
(00)owner
Please Input the code of command to be excute(0-0): 0
Please input a string:dlink(input owner name)
Key Word:
Q(quit)
(00)<cr>
Please Input the code of command to be excute(0-0): 0
Will you excute it? (Y/N):y
When the command "rmon collection stat" is used many times to configure the same index of collection
item, only the parameters of last time is available. You can use the command "no rmon collection stats
index" to delete the collection item whose index is index.
4.4.4 Configuring the RMON history function
RMON history function is used to collect the statistic information of a port in various times. The steps of
configuring the collection history are listed below:
Command
cd config
interface iftype ifid
rmon collection history
index
bucket-number]
second]
owner-name]
cd..
cd..
write
[DEFAULT@Router /E1/1/]#rmon
Key Word:
U(undo) D(default)
(00)collection
Please Input the code of command to be excute(0-0): 0
Key Word:
Q(quit)
(00)history
(01)stats
Please Input the code of command to be excute(0-1): 1
Key Word:
Q(quit)
(00)<1-65535>
Please Input the code of command to be excute(0-0): 0
Please input a string:100 (input index number)
Key Word:
Q(quit)
Model Name
Set the owner of this RMON collection
Enter the global configurative mode
Enter the interface configurative mode
iftype is type of the interface
ifid is ID of the interface
Enable the RMON collection history function of the interface:
[buckets
index is the index of history items
[interval
In all the statistics collected by the collection history function, item of
[owner
the nearest bucket-number must be saved. You can get these statistics by
browsing the Ethernet history record table. The default item number is 50.
second is the time interval between every two statistics acquisition.
The default interval is 1800 seconds(halfhour)
owner string is used to describe some descriptive message of the
collection history table
Back to the global configurative mode
Back to the management mode
Save the configuration
Q(quit)
Configure Remote Monitoring Collection on an interface
Configure history
Configure statistics
Set RMON history control index
Function
- 53 -