Table of Contents
Advertisement
Security System
User Guide
Move to Area (Cmd 50)
I can perform this command.
I cannot perform this command.
Use this command to operate multiple areas from the same command center when the system is split into more than one
area. Before operating another area, move the command center to the area that you want to operate.
1.
Press [CMD] [5] [0]. The command center may prompt you to enter a valid passcode.
2.
Enter your passcode if necessary. The command center scrolls through all available areas you can move to. In
this example, you are at Area 1 command center, which prompts you to press 2 to go to Area 2 or to press 3 to
go to Area 3:
3.
Press [CMD] to exit this feature.
4.
To return your command center to its "home" area, press and hold [CMD].
Auto-Forward On Setup (Cmd 83)
To utilize this command you must have "call forwarding" service from your local telephone company. Using that service,
your security system allows you to program the auto-forward on sequence that forwards all incoming calls to the telephone
number of your choice when you turn the system All On.
1.
Press [CMD] [8] [3]. The command center may prompt you to enter a valid passcode.
2.
Enter your passcode if necessary. The command center display scrolls:
3.
Enter the auto-forward off sequence to redirect all incoming calls.
46841D
To go to Area 2
Smiths Residence
Press 2.
To go to Area 3
Smiths Residence
Press 3.
To exit
Press Cmd.
Auto-Forward On
setup mode.
Enter digits for
Auto-Forward On
For 'pause' (P),
press All On.
For 'flash' (F)
press Part On.
A and C keys
move cursor.
To delete digit,
Press B key.
To view and edit
press Bypass.
To stop edit,
Press Bypass.
To exit,
Hold Cmd.
D623/D625 User Guide
Page 38
© 2003 Bosch Security Systems
Advertisement
Table of Contents
