Tacacs-Server Deadtime - Cisco MDS 9000 series Command Reference Manual

tacacs-server deadtime

S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
tacacs-server deadtime
To set a periodic time interval where a nonreachable (nonresponsive) TACACS+ server is monitored for
responsiveness, use the tacacs-server deadtime command. To disable the monitoring of the
nonresponsive TACACS+ server, use the no form of the command.
Syntax Description time
Defaults Disabled.
Command Modes
Configuration mode.
Command History Release
3.0(1)
Usage Guidelines Setting the time interval to zero disables the timer. If the dead time interval for an individual TACACS+
server is greater than zero (0), that value takes precedence over the value set for the server group.
When the dead time interval is 0 minutes, TACACS+ server monitoring is not performed unless the
TACACS+ server is part of a server group and the dead time interval for the group is greater than 0
minutes.
Examples
The following example shows how to set a duration of 10 minutes.
switch# config terminal
switch(config)# tacacs-server deadtime 10
Related Commands Command
deadtime
show tacacs-server
Cisco MDS 9000 Family Command Reference
23-6
tacacs-server deadtime time
no tacacs-server deadtime time
Specifies the time interval in minutes. The range is 1 to 1440.
Modification
This command was introduced.
Description
Sets a time interval for monitoring a nonresponsive TACACS+ server.
Displays all configured TACACS+ server parameters.
Chapter 23 T Commands
OL-8413-07, Cisco MDS SAN-OS Release 3.x