Restoring The Factory Setting; Resetting The Safety Functions To The Factory Setting - Siemens SINAMICS G120D Operating Instructions Manual

Commissioning

5.6 Restoring the factory setting

5.6 Restoring the factory setting
5.6.1 Restoring the factory setting
When must you reset the converter to the factory settings?
Reset the converter to the factory settings in the following cases:
• The line voltage was interrupted during commissioning and you were not able to complete
commissioning.
• You can no longer trace the settings that you made during commissioning.
• You do not know whether the converter was already operational.
Restoring the factory settings when the safety functions are enabled
If you are using the integrated safety functions of the converter, e.g. "Safe Torque Off", you must
reset the safety functions separately from the remaining converter settings.
The settings of the safety functions are protected by a password.
Settings that are not changed when restoring the factory setting
The communication settings and the settings of the motor standard (IEC/NEMA) are kept when
restoring the factory setting.
5.6.2

Resetting the safety functions to the factory setting

Procedure
1. Go online.
2. Select "Commissioning".
92
Converter with the control units CU240D-2
Operating Instructions, 10/2020, FW V4.7 SP13, A5E34262100B AH