Safety Instructions - Siemens Sinamics G120P Instruction Manual

Safety instructions

Validity
These instructions apply to the following converter:
Product
SINAMICS G120P
Prerequisites
You are proficient in working with the Microsoft® Windows™ operating system.
You have a good understanding of the principles of electronics and electrical engineering.
Warning
Dangerous currents and voltages!
The equipment contains dangerous voltages and controls potentially dangerous rotating mechanical
parts. Non-compliance with the warnings or failure to follow the instructions contained in the docu-
mentation can result in loss of life, severe personal injury or serious damage to property.
Take particular notice of the general and regional installation and safety regulations regarding work
on dangerous voltage installations (e.g. EN 50178) as well as the relevant regulations regarding the
correct use of tools and personal protective equipment (PPE).
Qualified Personnel
The device/system may only be set up and used in conjunction with this documentation. Only quali-
fied personnel may commission and operate this equipment. Within the context of the safety notes
in this documentation, qualified persons are defined as persons who are authorized to commission,
ground and label devices, systems and circuits in accordance with established safety practices and
standards.
Liability disclaimer
Depending on the firmware and software version of the Control Unit, operator panel and STARTER,
the masks, symbols and menus may differ. We have reviewed the contents of this publication to
ensure consistency with the hardware and software described. Since deviations cannot be pentirely
ruled out, we cannot guarantee full consistency. However, the information in this publication is
reviewed regularly and any necessary corrections are included in subsequent editions.