Advertisement
Operation
Instrument Controls Menu
TCP/IP Settings
3-40
Model 42i Trace Level Instruction Manual
In the Main Menu, choose Instrument Controls > Communication
●
Settings > RS-232/RS-485 Selection.
RS-232/RS-485 SELECTION:
XXXXXX** WARNING
DISCONNECT THE
CABLES BEFORE CHANGING
THE
SELECTION!XXXXXX
RANGE
AVG
DIAGS ALARM
The TCP/IP Settings menu is used for defining TCP/IP settings
Note The instrument power must be cycled after any of these parameters
have been changed for the change to take effect.
In the Main Menu, choose Instrument Controls > Communication
●
Settings > TCP/IP Settings.
Use DHCP
The Use DHCP screen is used to specify whether to use DHCP or not.
When DHCP is enabled, the network dynamically provides an IP address
for the instrument.
In the Main Menu, choose Instrument Controls > Communication
●
Settings > TCP/IP Settings > Use DCHP.
**XXXXXXX
SERIALX X
X
TO CONTINUE
TCP/IP SETTINGS:
>USE DHCP
IP ADDR
10.209.43.237
NETMASK
255.255.254.0
GATEWAY
HOST NAME
RANGE
AVG
DIAGS ALARM
RS-232/RS-485 SELECTION:
CURRENTLY:
SET TO:
MAKE SURE THAT THE
IS OFF: PRESS
RANGE
AVG
▲
OFF
10.209.42.1
iSeries
RS-232
RS-485 ?
CABLEXX
TO CONFIRM
TOGGLE VALUE
DIAGS ALARM
Thermo Fisher Scientific
Advertisement
Troubleshooting
